Luminaire conclusions
To meet various design requirements, three different luminaire conclusions are available for recessed downlights.
Standard ring
The basis is a particularly narrow standard ring with a recessed reflector.
Changing ring system
The changing ring system is flexible and multifunctional. The luminaire is delivered with an easy-to-assemble base ring and can be combined with many different accessories. The luminaire is delivered with a fixed ring. A separate cover ring is fastened by a bayonet lock.
Trimless-System
A special highlight is the plastered-in installation of luminaires. Our trimless system enables discreet, ceiling-flush or slightly recessed luminaire mounting. This requires a separately ordered plastering frame.
The trimless mounting system
The Trimless mounting system is used if the downlights should be an integral component of the architecture. The system perfects this contemporary design concept thanks to its completely frameless luminaire mounting.
The Trimless system features optimised versions for various ceiling systems and on-site situations. This ensures that architectural design concepts can be implemented without technical problems.
The trimless installation in cast concrete ceilings can be realised using specially developed cast-in housings. The use of a variable core element means this is also possible with bare concrete ceilings.
Trimless, flush
The plastering frame is covered by the lip of the reflector. The reflector edge sits in a slight recess and finishes flush with the ceiling.
Trimless, recessed
Edgeless installation using a plastering frame with a mounting sleeve. This sleeve is plastered over and painted in the final ceiling colour on-site.
Plaster mounting
Luminaire adapted to suit the ceiling system using a separate mounting frame. Optionally for flush installation or recessed installation. The plastering frame is fixed in the ceiling cut-out that was produced on-site and is secured using drywall screws. Fitting to the ceiling system is performed on-site. Luminaire housing for subsequent installation into finished ceiling.
Concrete housing
Concrete housing
The use of concrete housings allows recessed-mounted luminaires to be harmoniously integrated into the ceiling. Special adaptations also enable specific stress requirements to be met. This includes extended concrete inlets up to a maximum of 35mm in order to guide the armouring underneath the fitting. Flat or round fittings (with highly reduced volume) are available, depending on the ceiling situation. If round concrete castings are used, only specially adapted downlights can be used.
Specification
Sturdy one-piece housing made of galvanized sheet steel with a slanted concrete run. 2 to 4 entries for conduit. Attached throat can be extended as required. Maximum height 35mm. Fixing tabs for nail fastening to the wooden formwork. When installing in bare concrete ceilings, fixing with internal centring discs must be provided. Please order separately.